b'STEEL REUSABLE HOSE ENDSFOR USE WITH: S.A.E. 100R1-AT FOR USE WITH: S.A.E. 100R2-ATS.A.E. 37 S.A.E. 37. .Female FemaleMale Flare Male FlarePipe (Swivel) Pipe (Swivel)PART No.Hose I.D.Pipe PART No.Hose I.D.Tube PART No.Hose I.D.Pipe PART No.Hose I.D.TubeSRT125-4B 1/41/4 SRT138-44 * 1/41/4 SRT225-4B 1/41/4 SRT238-44 * 1/41/4SRT125-6C 3/83/8 SRT138-66 * 3/83/8 SRT225-6C 3/83/8 SRT238-66 * 3/83/8SRT125-8D 1/21/2 SRT138-88 * 1/21/2 SRT225-8D 1/21/2 SRT238-88 * 1/21/2SRT238-1212 * 3/43/4* Item is available in stainless steel.Change pre x to SS * Item is available in stainless steel.(eg. SSRT238-44)Change pre x to SS(eg. SSRT238-44) ASSEMBLY INSTRUCTIONS FOR NON-SKIVE S.A.E. 100R1, 100R2 & 100R5 STEEL REUSABLE HOSE ENDSSTEP 1 STEP 2 STEP 3 STEP 4 STEP 5Using ane-toothed saw orDip the end of the hose into aTurn the hose counterclockwiseDip the nipple end into aTurn the stem clockwise into cut-off wheel, cut the hoselubricant. Use a light viscosityinto the socket until the hoselubricant. Refer to step 2. (Lightthe hose and socket until the square to the desired length. oil (S.A.E. 10 or 20) bottoms. weight oil S.A.E. 10 or 20). stem hex shoulders against the Clean hose with air pressure toferrule.remove dust particles.CAUTION: Larger diameter hose is subject to Neck Down during cut-off operations.This condition does not allow the nipple to be pushed into the hose.When this happens, that portion of the hose I.D. must be chamfered with a sharp knife, just enough to allow the nipple to be pushed into the hose. Be sure to remove the cut-off rubber from the assembly.IMPORTANT:Back the hose off at least 1/2 turn, check to be sure that there is a gap of 1/32 to 1/16 between the hose end and the shoulder on the inside of the socket.Failure to provide this gap may cause cracking of the socket.ONE PIECE CRIMP ENDS FOR PTFE HOSEFOR USE WITH S.A.E. 100R14 SMOOTH BORE PTFE HOSE (Page 100)ALL WETTED PARTS ARE BRASS.Male S.A.E. 37Pipe FemaleFlare(Swivel)Nominal NominalPART No.Hose I.D.Tube PART No.Hose I.D.TubeSCT425-4A1/41/8 SCT438-441/41/4SCT425-4B1/41/4 SCT438-663/83/8SCT425-6C3/83/8 SCT438-881/21/2SCT425-8D1/21/2 SCT438-10105/85/8SCT425-10D5/81/2 SCT438-12123/43/4SCT425-12E3/43/472'