b"STEEL CRIMP HOSE ENDSFOR USE WITH SEWER CLEANING HOSE (Page 98)Male Pipe SplicerBPART No. Hose I.D. Pipe PART No. Hose I.D.SCH25-8D 1/2 1/2 SCH29-88 1/2SCH25-12E 3/4 3/4 SCH29-1212 3/4SCH25-16H 1 1 SCH29-1616 1HYDRAULIC CRIMP INSTRUCTIONS1. Cut hose to length.Using a cut-off saw or cut-off wheel, cut the hose square to thedesired length.1. Clean hose with air pressure to remove dust particles.2. Mark insertion Depth. Find the insertion depth by measuring the distance from the end ofthe ferrule to the shoulder of the ferrule.Using a ruler or by holding the hose next to the ferrule, mark a line2. on the hose indicating the insertion depth.3. Lubricate hose with hose assembly lubricant.Place a small amount of lubricant on the outer and inner tubeportion of the hose. Only use approved hose assembly lubricant.Other non-approved lubricants or oil products may not be3. compatible with hose material.4. Insert fitting into hose. Push the fitting into the hose until the insertion depth mark lines upwith the end of the ferrule.4.5. Insert Hose into crimping machine.When crimping Fairview's SC600 and SCK600 Series, align thedots on the ferrule with the top of the dies. (figure 1)When crimping Fairview's SC500, SC900 and SCT900MSSeries,5. align the top shoulder of the ferrule with the top of the dies andcrimp the entire ferrule. (figure 2)figure 1 figure 26. Check Crimp Diameter.After crimping verify crimp diameter is within specifications usingcalipers. Place caliper on the lower or smooth portion of the ferrule.Do not place calipers on any raised ridges on the ferrule. Measure6. the top, middle and bottom of the ferrule to ensure crimp diameteris correct and uniform.All Hydraulic Assemblies should be pressure tested prior to use.85"